Epson 468C Saving Your Settings and Exiting SETUP, SAVE, Write to CMOS RAM and exit (Y/N)

Saving Your Settings and Exiting SETUP

When you leave SETUP, you can either save the settings you have changed or exit the program without saving any changes.

To save your settings, follow these steps:

1.Press to return to the main SETUP menu.

2.Select option 6, SAVE settings and exit, and press [Enter. You see this message:

Write to CMOS RAM and exit (Y/N)?

3.Press and The system reboots.

4.If you have just run SETUP for the first time, see “Post-SETUP Procedures,” below.

To exit SETUP without saving the setting, select option 7,

Exit without saving settings. The system reboots with your original settings.

N o t e

If your computer detects a problem in your SETUP configuration, you may see an error message and a prompt to run SETUP when it is rebooting. Follow the instructions on the screen to run SETUP and correct the problem.

You may also see an error message when your computer is rebooting if you have not installed your operating system on the hard disk and you did not insert a system diskette in drive A. If you receive this error message, follow the instructions in your operating system manual to install it.

2 - 1 8 Running the SETUP Program