After you install or remove your drive(s) and replace the computer’s cover, follow the steps below to make sure your new configuration works properly:
1.Run the SETUP program to configure your computer for your new set of drives. See Chapter 2 for instructions.
2.If you installed a
3.You may need to format the drive before you can use it. (All Epson drives are sold already formatted.) Check the manual that came with the drive to see if it is already formatted. If not, follow the manufacturer’s instructions to format the drive.
4.If you want to be able to load your operating system from a new hard disk drive, you need to install it on the drive. See the documentation that came with your operating system for instructions.
Installing and Removing Drives 5 - 33