Caution

When performing the BI-D alignments, always do them in this order: UNI-D ALL, then BI-D BLACK, then BI-D ALL. Do not repeat the BI-D BLACK (K1) alignment afterward.

Setting Up the Printer 57

Aligning the Print Head

Before using the printer, you should align the print head to ensure clean, accurate printouts. To do the alignment, you have to print a set of alignment patterns. Make sure you’ve run a nozzle check, as described on page 54, before you begin. If the print head nozzles are clogged, the patterns won’t print correctly and your print head alignment won’t be accurate.

1.Make sure the printer is turned on, then load roll paper that is at least 24 inches wide. For best results, use EPSON Doubleweight Matte paper (this is the type of paper that came with your printer).

2.Press the SelecType button on the control panel. You see PRINTER SETUP.

3.Press u until you see HEAD ALIGNMENT, then press r. You see

PAPER THKNS.

4.Press r until *STD appears on the display. This is the correct thickness setting for most EPSON papers.

5.Press Enter.

6.Press the u or d button to select the desired alignment mode (UNI-D ALL, BI-D BLACK, or BI-D ALL), then press Enter to start printing the alignment patterns. After they print, see the appropriate section on the following pages, depending on the selected mode.

In general, you should perform all three types of alignments. If you plan to print only unidirectionally, you may only need to adjust UNI-D ALL. If you plan to print bidirectionally, perform the UNI-D ALL alignment first, then BI-D BLACK, then BI-D ALL.