COMMAND 61: AUTOMATlC PRINT ORIENTATION (APO) (LASER)
Laser printers automatically control page orientation if the user decides to activate auto print orientation (APO). Refer to the page orientation logic chart in the computer output reduction section of the manual.
VALUE DESCRlPTlON
*0 Auto Print Orientation (APO) is ACTIVE. The page dimensions of a document are checked to determine if the data should be printed in landscape because the width is greater than the length.
1Auto Print Orientation (APO) is NOT ACTIVE. Print orientation is controlled by the orientation selections specified in Commands 62, 63, and 64.
NOTE: APO active is the recommended selection.
A user can manipulate the page dimensions using SCS commands to control the orientation of the printing as long as the page size required is 8 1/2" X 11” or smaller.
EXAMPLE: &%Z61 ,1 | APO is not active. |
COMMAND 62: PRIMARY PAPER TRAY ORIENTATION (LASER)
The SCS (LU1) PPM command, which specifies the source for the paper, assigns a printing orientation to the primary paper tray. Refer to the page orientation logic chart in the computer output reduction section of the manual. This command duplicates the IBM 3812 and 4028 printer’s feature with the additional selection of option 3 below.
VALUE DESCRlPTlON
*0 Computer Output Reduction (COR) Mode is active when paper is specified to be selected from the primary tray.
1PORTRAIT orientation will occur using the active font when the primary tray is specified.
2LANDSCAPE orientation printing occurs using the active font when the primary tray is specified.