BUTTON SPECIFICATIONS
Button | Functions |
Top | PA1 response when the PA red LED is on |
| Prints out a page listing when pressed and held for 2 seconds. If the |
| coax cable is disconnected, then a RAM/ROM self test is also |
| performed and the results are printed. |
| YES response during push button setup (see Appendix B) |
Bottom | PA2 response when the PA red LED is on |
| Begins restoration of factory default setup (see “Restoring Factory |
| Default Configuration’section) |
| NO response during push button setup (see Appendix B) |
Both | After turning on, if both buttons are pressed and released (for less |
| than one second) a cancel signal is sent to the host. The red LED |
| will blink twice times to confirm the cancel signal was sent. (Note: |
| The printer will continue printing until its buffer is empty.) |
| After turning on, if both buttons are pressed and held more than two |
| seconds, the interface enters the hexadecimal (buffer dump) |
| diagnostic printing mode. The printer then prints “Buffer print is |
| active’and the green LED will blink twice. Turn off the printer to exit |
| this mode or press and hold both buttons for more than two seconds |
| which will cause the green LED to blink twice. (Also, see Command |
| 42 in Appendix A for a download command.) |
I N S T A L L A T I O N
CONTENTS OF INTERFACE KIT
Make sure the interface kit includes all items listed below:
Coax interface card
PC Auto Parallel Sharing Cable
User’s guide