NOTES: Previously stored substitutions are automatically changed to the new selection when the same hex location is specified in the EBCDIC table.
Previously stored substitutions are cancelled if an ASCII hex sequence of 00 is specified.
Command ‘Z99,0’must be used to store the substitutions in NV Memory for them to be effective when the printer is next turned on.
The active EBCDIC (SCS/LU1) translation table prints out at the end of the interface
EXAMPLE: &%Z70,7B,40/Z99,0 Overwrites the ASCII hex output for the EBCDIC 7B (a # symbol) to send a 40 ASCII hex which will print a @ symbol instead. The command is followed by a command ‘Z99,0 which stores the active setup selections in
COMMAND 71: OVERWRITE DSC (LU3) TRANSLATION TABLE
Custom substitutions defined by this command, and stored in the NV memory, are overwritten into the DSC (LU3) to ASCII translation table.
NOTES: This command functions identically to Command 70 except that the substitutions are applicable to the DSC (LU3) translation table. Refer to the Command 70 instructions.
The active DSC (LU3) translation table prints out at the end of the interface
COMMAND 98: RESTORE DEFAULTS CR PRINT CONFIGURATION
Restores the factory default configuration selections, prints out a copy of the active configuration selections, or restores the non volatile memory (NV) selections to the active configuration status.