EPSON AcuLaser C9200 Series User's Guide

5.Select the Create a new port check box and select Standard TCP/IP Port from the drop-down list. Click Next.

6.Click Next.

7.Specify the IP address and port name, then click Next.

8.Click Finish.

9.Click Have Disk in the Add Printer Wizard and specify the following path for the CD-ROM. If your CD-ROM drive is D:, the path will be D:\ADOBEPS\ENGLISH\PS_SETUP.

Then click OK.

Note:

Change the drive letter as needed for your system.

10.Select the printer and click Next.

11.Follow the on-screen instructions for the rest of the installation.

12.When installation is done, click Finish.

Accessing the PostScript printer driver

You can change the PostScript printer driver settings in the PostScript printer driver. To access the printer driver, see “Accessing the printer driver” on page 216.

Using AppleTalk under Windows 2000

Use the following settings if your machine is running Windows 2000, and the printer is connected through an network interface using the AppleTalk protocol:

❏Select PS3 as the Network setting in the control panel’s Emulation Menu.

❏On the Device Settings sheet of the printer’s Properties dialog box, make sure that SEND CTRL-D Before Each Job and SEND CTRL-D After Each Job are set to No.

❏TBCP (Tagged binary communications protocol) cannot be used as the Output Protocol setting.

About the PostScript Printer Driver 243