EPSON AcuLaser C9200 Series User's Guide

USB Menu

Item

Settings (default in bold)

 

 

USB I/F*1

On, Off

USB Speed*1 *2

HS, FS

Get IP Address*2 *3

Auto, PING, Panel

IP*2 *3 *4 *5

0.0.0.1 to 255.255.255.254

 

 

SM*2 *3

0.0.0.0 to 255.255.255.255

 

 

GW*2 *3

0.0.0.0 to 255.255.255.255

 

 

NetWare*2 *3

On, Off

AppleTalk*2 *3

On, Off

MS Network*2 *3

On, Off

Bonjour*2 *3

On, Off

USB Ext I/F Init*2 *3

-

Buffer Size*1 *2

Normal, Maximum, Minimum

*1 After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again. While it is reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is turned on again.

*2 Available only whenUSB I/F is set to On.

*3 Available only when a USB external device with D4 support is connected. The contents of the settings depend on the USB external device settings.

*4 If theGet IPAddress setting is set to Auto, this setting cannot be changed.

*5 When theGet IPAddress setting is changed from Panel or PING to Auto, the panel setting values are saved. Then Auto is changed back to Panel or PING, the saved setting values are displayed. The value is set to 192.168.192.168 if the settings are not made from the panel.

USB I/F

Allows you to activate or deactivate the USB interface.

USB Speed

Allows you to select the operation mode of USB interface. Selecting HS is recommended. Select FS if HS does not work on your computer system.

Using the Control Panel 94