EPSON AcuLaser C9200 Series User's Guide

Item

Settings (default in bold)

 

 

Parallel I/F*

On, Off

Speed*

Fast, Normal

Bi-D*

ECP, Off, Nibble

Buffer Size*

Normal, Maximum, Minimum

*After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again. While it is reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or after the power is turned on again.

Parallel I/F

Allows you to activate or deactivate the parallel interface.

Speed

Specifies the pulse width of the ACKNLG signal when receiving data in the Compatibility mode or Nibble mode. When Fast is selected, the pulse width is about 1 μs. When Normal is selected, the pulse width is about 10 μs.

Bi-D

Allows you to specify the bidirectional communication mode. When you select Off, bidirectional communication is disabled.

Buffer Size

Determines the amount of memory to be used for receiving data and printing data. If Maximum is selected, more memory is allocated for receiving data. If Minimum is selected, more memory is allocated for printing data.

Note:

❏To activate Buffer Size settings, you must turn off the printer for more than five seconds then turn it back on. Or, you can perform a Reset All operation, as explained in “Reset Menu” on page 91.

❏Resetting the printer erases all print jobs. Make sure the Ready light is not flashing when you reset the printer.

Using the Control Panel 93