Epson ELP-820, ELP-811, ELP-600, ELP-800UG, ELP-810UG, EMP-810UG Projecting No abnormality Progress

Troubleshooting

Indicator status		Projector	Problem and remedy	Reference
		status		page
red	orange	High-speed	(This is not an abnormality, but if the	P.18
		cooling in	temperature rises too high again, projection	P.92
		progress	will stop automatically.)

•Set the projector up in a place which is well-ventilated, and so that the air inlet and exhaust vents are clear.

•Clean the air filter.

orange	Lamp will soon	Have a new replacement lamp ready.	P.94
	need to be	The lamp service life can become shorter than
	replaced.	normal as a result of the usage conditions,
		and so the lamp should be replaced as soon as
		possible.

*The appearance of the operation indicator at this time will vary depending on the sta- tus of the projector.

orange	Standby	(No abnormality)	P.37
	condition	Projection starts when the [Power] button is
		pressed.
green	Warm-up in	(No abnormality)	P.37
	progress	Wait for a short while. The indicator will stop
		flashing and light with a green color.
green	Projecting in	(No abnormality)	P.37

progress

orange	Cool-down in
	progress

(No abnormality) P.39

•Wait for a short while.

The cool-down (lamp cooling operation) period lasts for about 2 minutes. The actual time will vary depending on the external air temperature.

•The [Power] button will not operate during the cool-down period. When cool-down is complete, the indicator will stop flashing and light orange. You can then use the [Power] button.

Tip :

•If the projector is not operating properly even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" on the following page.

•If an indicator is showing a status which does not appear in the previous tables, contact your dealer or the nearest address provided at “International Warranty Conditions” in Safety Instructions/World-Wide Warranty Terms included in the package.

82