Introduction 14
8Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in the Off
position.
9Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the printer is in
use.
10 Airflow vents
These vents vent air from inside the printer. Do not obstruct these vents.
11 Waste ink bottle (tank) holder
Place the waste ink bottle in this holder.
12 Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
13 Waste ink bottle (tank)
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
14 Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in use.
15 Ink cartridges
Install all ink cartridges into each slot.
16 Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place after insertion.
17 Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the message on the control panel’s screen.
Off : No error.
18 AC inlet #1/AC inlet #2
Connects the power cable. Be sure to connect both cables.
19 LAN port
Connects the LAN cable.
20 USB port
Connects the USB cable.
21 Maintenance cover (right)
Open this cover when performing regular maintenance. Normally closed when using the printer.
See “Regular Maintenance” on page 121.
22 Media loading lever
After loading media, lower the media loading lever to keep the media in place. Raise the lever to release the media prior to
removal.
23 Alert lamp
This lamp lights or flashes when an error occurs.