Basic Operations 75
Keep the right edge of the media parallel with the scale markings on the two labels on
the right side of the after heater.
15.Lower the media loading lever to hold the media in place.
To print immediately, proceed to Step 16.
For information on loading the media into the auto take-up reel unit, see “Using the Auto
Take-up Reel Unit” on page 82.
16.Attach the media holding plates at either side of the media.
Note:
If you would prefer to print from the very start of the roll, press the u button in the control
panel to rewind the media slightly.
Be sure, however, to stop rewinding before the leading edge of the media is over the cutter
groove (on the pressure roller side).