Introduction 8
❏The printer requires two power cables with a combined capacity of 20 A at 100 V or 10
A at 240 V. If the combined capacity can not be supplied by a single outlet, connect the
cables to different outlets with independent power sources.
❏If you plan to use the printer in Germany, observe the following:
To provide adequate short-circuit protection and over-current protection for this printer,
the building installation must be protected by a 10 or 16 amp circuit breaker.
❏If damage occurs to the plug, replace the cord set or consult a qualified electrician. If
there are fuses in the plug, make sure you replace them with fuses of the correct size
and rating.
When using this product❏Do not block or cover the openings in this product’s cabinet.
❏Do not insert objects through the slots. Take care not to spill liquid on this product.
❏Do not attempt to service this product yourself.
❏Unplug this product and refer servicing to qualified service personnel under the
following conditions: The power cord or plug is damaged; liquid has entered the
product; the product has been dropped or the cabinet damaged; the product does not
operate normally or exhibits a distinct change in performance.
❏Always turn the product off using the Power button on the control panel. When this
button is pressed, the Power light flashes briefly then goes off. Do not unplug the power
cord or turn off the product until the Power light stops flashing.
❏This device has two power systems. There is a risk of electric shock unless the two
power cables are unplugged during maintenance.
When handling the ink cartridges❏Keep ink cartridges out of the reach of children and do not drink.
❏Do not touch the green IC chip on the side of the cartridge. This may affect normal
operation and printing.
❏The IC chip on this ink cartridge retains a variety of cartridge-related information, such
as the ink cartridge status, so that the cartridge may be removed and reinserted freely.