Introduction 19
LAN port
5Pre-heater
Heats the media before printing so that the print area is not subject to sudden changes in temperature.
6 Roll support
Rest media on these supports before placing it on the roll holders. There are two supports: one on the left and one on the right.
7Handle
After placing media on the right roll holder, rotate the handle to press the holder and apply pressure to the roll core.
1RJ-45 connector
Connects the LAN cable. Use a shielded twisted pair cable (category 5 or higher).
2 Data lamp
The data lamp shows connection status and indicates whether the printer is receiving data.
3 Status lamp (green/red)
The status lamp indicates network connection speed.
Data lamp Status lamp (green/red) Status
On On (green) The printer is connected using a
1000base-T connection.
Flashing The printer is receiving data over a
1000base-T connection.
On On (red) The printer is connected using a
100base-TX connection.
Flashing The printer is receiving data over a
100base-TX connection.