Extron electronic 1600 setup guide Front Panel Operations, Creating a Tie

Remote port connector

		Pin RS-232 Function			RS-422 Function
		1	—	Not used	—	Not used
5	1	2	Tx	Transmit	Tx–	Transmit (–)
		3	Rx	Receive	Rx–	Receive (–)
		4	—	Not used	—	Not used
		5	Gnd	Ground	Gnd	Ground
9	6	6	—	Not used	—	Not used
		7	—	Not used	Rx+	Receive (+)
		8	—	Not used	Tx+	Transmit (+)
		9	—	Not used	—	Not used

Figure 8. Remote RS-232/RS-422 Output Connector Wiring

Front Panel

		CONTROL				I/O
CONFIG	ENTER	PRESET	VIEW	ESC	VIDEO	AUDIO

PRIMARY 1 2

REDUNDANT 1 2

POWER

XTP CROSSPOINT 1600

XTP SERIES DIGITAL MATRIX SWITCHER

1 2

Figure 9. Front Panel Features

AConfiguration port — If desired, connect a control system or computer to the front panel Configuration port, a mini USB B port.

BPrimary and Redundant Power Supply LEDs —

NOTES:

• The XTP CrossPoint 3200 has four power supplies installed and indicated.

• The XTP CrossPoint 1600 has two power supplies installed and indicated in its standard configuration (only two LEDs lit). It is available in a four-power-supply, redundant power upgrade configuration, in which it indicates all four supplies.

Front Panel Operations

This section describes simple XTP CrossPoint matrix switcher operation from the front panel. Topics that are covered include:

•• Creating a Tie

•• Saving or Recalling a Preset

•• Setting the Front Panel Locks (Executive Modes)

•• Viewing and Adjusting the Audio Level

•• Viewing Ties (and Muting Outputs)

Creating a Tie

A "tie" is an input-to-output connection.

A "set of ties" is an input tied to two or more outputs. (An output can never be tied to more than one input.)

A "configuration" is one or more ties, one or more sets of ties, or a combination.

1.Press and release the Esc button to clear any input button, output button, or control button indicators that may be lit.

2.Press and release the Video and Audio I/O buttons to select or deselect video, audio, or both as desired.

	I / O
Green when selected			Red when selected
	VIDEO	AUDIO
Off when deselected			Off when deselected

NOTE: Audio or video can be broken away (tied by itself) by

selecting only the Video button or only the Audio button.

3.Press and release the desired input button.

The button lights to indicate the selection.

5

4.Press and release the desired output buttons.

Green — Indicates that the associated power supply is operating within normal tolerances.

Red — Indicates that the associated power supply is operating outside the normal tolerances or has failed.

Amber indicates video and audio tie. Green indicates video only tie.

Red indicates audio only tie.

3 4 8

ENTER

Green indicates the need to confirm the change.

5.Press and release the Enter button. All button indicators turn off.

16 XTP CrossPoint 1600 and 3200 • Installation XTP CrossPoint 1600 and 3200 • Front Panel Operations 17