FOutput connectors —
•DSC
•DSC
G
Securing the HDMI Connector Using the LockIt Bracket
After connecting an input or output device to an HDMI connector, secure the connector in place with the provided LockIt bracket as follows:
1.Plug the HDMI cable into the panel connection.
2.Loosen the HDMI connection mounting screw from the panel enough to allow the LockIt lacing bracket to be placed over it.
3.Place the LockIt lacing bracket onto the screw and slide it up against the HDMI connector. Tighten the screw to secure the bracket.
4.Loosely place the included tie wrap around the HDMI connector and LockIt lacing bracket.
5.While holding the connector securely against the lacing bracket, tighten the tie wrap, then remove any excess length.
2 1
OUTPUT
3
4
3
Connecting for Remote Control
Both DSC models have two control ports through which they can be connected to your computer for configuration and control: the rear panel
Connecting to the RS-232 Port
To connect your computer or control system to the DSC
Extron Universal Control cable (UC50' or UC100') or other female
1.If the provided
2.Wire the unterminated end of the
a.Connect the transmit wire to the left pin, which plugs into the Tx (transmit) port.
b.Connect the receive wire to the fourth pin, which plugs into the Rx (receive) port.
c.Connect the ground wire to the last pin, which plugs into the ground port, marked with G.
DSC | 7 |