Power Save Mode
In power save (standby) mode, all
•To enable power save mode, enter the Power Save ON SIS command (see the Power Save Mode commands on page 55).
•To exit power save mode, either enter the Power Save OFF SIS command or press any front panel button (if the front panel is locked, this method does not work).
NOTE: The backup and restore functions available through the PCS control software are not accessable while the unit is in power save mode.
Presets
A preset is a set of input parameters that are either saved by you or automatically by the DSC as a files in DSC memory. Saved presets can be recalled and their settings implemented at any time. A preset saves time by enabling you to apply a group of settings to the DSC at one time.
The DSCs have three types of presets: Auto Memories, user presets, and global input presets.
Auto Memories
The DSC has 32 memory locations in which the current input configuration and picture control values are automatically stored as an input preset, when Auto Memory is enabled. An Auto Memory preset is recalled when an identical input resolution and rate is applied to the input.
Each Auto Memory preset is stored with a time stamp that is incremented each time its stored rate is detected. If all Auto Memory slots are occupied and a new rate is applied, the Auto Memory with the oldest time stamp is overwritten.
Auto memory can be enabled using the OSD (see the Auto Memory option of the Advanced submenu on page 33) and by SIS commands (see the Auto Memories commands on page 53).
The following information is stored in an Auto Memory preset:
• | Contrast | • | Active lines (V Active) |
• | Brightness | • | Horizontal image position |
• | Detail | • | Vertical image position |
• | Horizontal start | • | Horizontal image size (width) |
• | Vertical start | • | Vertical image size (height) |
• | Active pixels (H Active) | • | Total pixels |
DSC | 38 |
