Extron electronic DSC 3G-HD A, DSC HD-3G A manual X2% , X1$ Pnam, X1$ =

Command	ASCII Command	Response	Additional Description
	(Host to Scaler)	(Scaler to Host)
Presets
Auto Memories
Enable	E 1 * 1 AMEM }	Amem 1 * 1 ]	Set Auto Memory to On.
			Settings are automatically
			stored as presets. Previous
			settings for the incoming signal
			are recalled.
Disable	E 1 * 0 AMEM }	Amem 1 * 0 ]	Set Auto Memory to Off.
			Manual recall of input presets is
			required to configure the input.
View setting	E 1 AMEM }	X1) ]	View current Auto Memory
		In verbose modes 2 and 3:	status X1).
		Amem 1 * X1) ]

Values Saved in User and Input Presets:

User Presets

Input Presets

Contrast	H Image Size	Contrast	H Start	H Image Position
Brightness	V Image Size	Brightness	V Start	V Image Position
Detail	H Image Position	Detail	H Active (Pixels)	H Image Size
Preset Name	V Image Position	Film Mode	V Active (Lines)	V Image Size
		Audio Gain/Attenuation	Total Pixels	Preset Name

User Presets

Recall preset	1 * X2% .	1 Rpr X2% ]	Recall user preset X2% for the
			selected input.
Save preset	1 * X2% ,	1 Spr X2% ]	Save user preset X2% for the
			selected input.
Delete (clear) preset	E X 1 * X2% PRST }	Prst X 1* X2% ]	Clear user preset X2% and set
			its name to [unassigned].

User Preset Name

Write name E 1 * X2% , X1$ PNAM }

Pnam 1* X2% , X1$ ]

Read name	E 1 * X2% PNAM }	X1$ ]
		In verbose modes 2 and 3:
		Pnam 1 * X2% , X1$ ]

Set the name of user preset X2% to X1$.

View the name of user preset X2%.

NOTE: Unnamed presets are shown as [unassigned]. To restore a default user preset name, enter a single space character for X1$. These entries are valid only for previously saved presets.

NOTE: X1)	=	Enable or disable Auto Memory: 0 = Off or disable, 1 = On or enable
X1$ =		Preset name, up to 16 characters
X2%	=	User preset number: 1 – 3
		Response is 2 digits padded with a zero.
		DSC 3G-HD A and DSC HD-3G A • Remote Configuration and Control	53