Extron electronic DVS 204 D 12V, DVS 204 12V Outputs 7 and, DVS 204 Installation and Operation

4Video input 3: S-video — Connect an S-video signal to this 4-pin mini-DIN female connector.

5SDI (serial digital interface) input connector — Connect an SDI signal to this female BNC connector.

S-VIDEO

3

SDI

Only the DVS 204 D and DVS 204 D 12V models have an SDI connector.

6Video input 4: RGB pass-through, RGBS, or RGBcvS — Connect an RGB pass-through (RGBHV, RGBS, RGsB), RGBS, or RGBcvS video signal to this 15-pin HD connector. The pass-through signals are not scalable.

Equipment following the SCART interconnection standard may be connected to the RGBcvS input cabling configuration.

RGB

PASS - THRU/

RGBS/RGBcvS

4

7RGB (RGBHV, RGBS, RGsB) or HD component (R-Y, Y, B-Y) video BNC output — Connect coaxial cables from a display device to these BNCs for a scaled or pass-through RGB or a scaled component video output. The output can be scaled to 56 different output rates. The scaled inputs (1-3) are output, as shown below.

The default for the “H” BNC connector is always horizontal sync. See the following section “RGB pass-through”, for the only exception to this rule.

	RGBHV*			RGBS
R	OUTPUTS	B	R	OUTPUTS	B
	G			G
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V	S	H	V	S
R	OUTPUTS	B	OUTPUTS		B
	G		R	G
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H	V	S	H	V	S

RGsB	Component Video (R-Y, Y, B-Y)
Outputs 7 and 8	are both buffered and can be connected simultaneously

to two different displays. For RGB inputs, the output signal’s sync format is based on the format of the incoming RGB signal. For all other types of inputs, the user selects the output sync format. The sync format will be the same for both outputs.

RGB pass-through— An RGB pass-through signal with composite sync (“RGB” is selected for input 4; see the Input Configuration section in this chapter) will always output composite sync through the “H” BNC output connector, as shown in the following illustration.

If both an RGB pass-through signal with composite sync and a scaled video input (1-3) are output as RGBS, the H Format must be set to “HV” (composite sync). This will cause the scaled video input to output composite sync on the same connector (the “H” BNC) as the pass-through signal instead of the “S” BNC. See the H Format section in this chapter.

For scaled inputs on input 4 (RGBS or RGBcvS), the H Format will not have to be set to “HV” since those inputs will be output like inputs 1-3, as shown in the previous connection diagram.

DVS 204 • Installation and Operation 2-5