Appendix, cont’d

U17

U41

U38

Locating the three firmware IC chips

5.After you are electrically grounded, the U17 IC chip or U38 IC chip may be removed by grasping it firmly with your fingers and pulling it out, then continuing to step 8.

Removal of the U41 IC chip requires a PLCC IC puller tool. To remove the U41 chip, align the hooks of a PLCC IC puller tool with the slots located in opposite ends of the U41 firmware chip.

6.Insert the hooks into the slots, and squeeze the tool

gently to grasp the chip.

7.Pull the chip straight out

of the socket, and set it

Align Notches

aside.

U41

8.For U17 and U38, align

the notch of the new firmware chip with the notch of the socket in the

same orientation as the old chip.

For U41, align the angled corner of the firmware chip with the angled corner of the socket.

9.Gently, but firmly, press the chip into place in the socket.

10.Replace the top cover on the DVS 204 scaler, and fasten it with the screws that were removed in step 3.

11.Rack/furniture mount the scaler, and reconnect the AC or DC power cord.

A-6 DVS 204 • Appendix

Page 48
Image 48
Extron electronic DVS 204 D 12V, DVS 204 12V manual U17 U41 U38