Extron electronic DVS 204 D manual Output Configuration, Input 2 Video Type, Input 4 Video Type

Input 1 can only input composite video, and Input 3 can only input S-video, no other video types are selectable for these inputs. Only Inputs 2 and 4 offer selectable video types. From the Input Configuration menu, pressing the Next key successively will display submenus with the input video types for Inputs 2 and 4. The SDI input (if any) can be assigned to any input from the Input Configuration submenus.

Input 2 Video Type

Rotate either the Adjust horizontal () knob or Adjust vertical () knob while in the Input 2 submenu to select the appropriate video format (composite, S-video, component) for Input 2. The default is component video.

Input 4 Video Type

Rotate the Adjust horizontal () knob while in the Input 4 submenu to select the appropriate video format (RGB pass-through, RGBS, RGBcvS) for Input 4. The default is RGB pass-through.

SDI input (SDI IN)

Rotate either the Adjust horizontal () knob or Adjust vertical () knob while in the SDI Input submenu to select the input # for the SDI input. The SDI input can be assigned to Inputs 1, 2, 3, 4, or none (*). The default is none.

After the SDI input is no longer assigned to an input, either because it has been assigned to a new input or is set to none, the input reverts back to the last video type that was assigned to it.

Output Configuration

The following flowchart provides an overview of the Output Configuration submenus and the options for each setting.

Extron

DVS204D

MENU

INPUT

CONFIG

MENU

OUTPUT CONFIG

NEXT

640 x

NEXT

SIGNAL

NEXT

H SYNC V

NEXT

480 @ 60

RGB

NEG

POS

Scaler output rates

Output video types

Sync polarity combinations

•

See the scaler output table in this

•

RGB (default)

•

H-/V- (default)

•

H+/V-

chapter for available combinations of

• YUV

•

H-/V+

•

H+/V+

resolutions and refresh rates.

•

RGsB

NOTE

This submenu is only active if RGB

Default: 1024 x 768 @60 Hz

is selected as the output video type.

If the signal type was specified as

RGsB or YUV in the previous submenu,

the sync polarity submenu will not display.

NEXT

H FORMAT

<H> HV

Select where to output composite sync

•H (default) – outputs horizontal sync through the "H" BNC

•HV – outputs composite sync through the "H" BNC

NOTE See the section "RGB pass-through" under the Rear Panel Features section of this chapter for further details.

DVS 204 • Installation and Operation 2-11