Extron electronic DVS 204 Advanced Configuration, Recalling a preset, Detail control, Filter mode

Recalling a preset

Recalling a saved preset requires that the desired input be currently selected and that the input button be pressed successively to activate each saved preset (up to three). Each saved preset will display the LCD message “Input #X Memory Y” where “X” refers to the input (1 to 4) and “Y” refers to the preset (1 to 3).

The absence of any saved presets will not display the “Input #X Memory Y” LCD message for the absent preset.

The presets are specific to a selected output rate. If the output rate is subsequently changed, the previously saved preset will have no effect on the video output. However, if the original output rate is later restored for a saved preset, the preset will again apply to that output rate.

Advanced Configuration

The following flowchart provides an overview of the Advanced Configuration submenus and the options for each setting.

EXTRON DVS204D

MENU

INPUT

CONFIG

MENU

OUTPUT CONFIG

MENU

BLANKING

CONFIG

MENU

MEMORY PRESET

MENU

ADVANCED

CONFIG

NEXT

DETAIL 016

NEXT

FILTER

OFF <ON>

NEXT

BLUEMODE <OFF> ON

NEXT

AUTOSW

<OFF> ON

NEXT

Either Adjust knob is used to adjust the submenus

Detail (sharpness)

•Ranges from 0 to 63. (default is 16)

Filter

• On (default)

• Off

Display blue and sync only

•On

•Off (default)

Autoswitch mode

•On

•Off (default)

NEXT

RGB DLY 0.0 SEC

NEXT

2:2 PLDN <OFF> ON

NEXT

ENH MODE <OFF> ON

RGB delay time

•0.0 to 5.0 seconds

in 0.5 sec. increments.

(default is 0.0)

PAL film mode (2:2 pulldown detection)

•On

•Off (default)

Enhanced mode (gain control)

•Off (default)

•On

Detail control

This submenu allows adjustment of the image detail (sharpness) of the output display. The adjustment ranges from 0 to 63. The default is 16.

Using either the Adjust horizontal () or Adjust vertical () knob, adjust the detail while observing the output display.

Filter mode

The Filter mode, when set “On”, reduces or eliminates aliasing and the resultant “jail bar” effect. For digital displays, set the filter “On” to reduce or eliminate high frequency noise. For CRT output, set the filter “Off”.

Use either the Adjust horizontal () or Adjust vertical () knob to specify this mode as “On” or “Off”. The default is “On”.

DVS 204 • Installation and Operation 2-15