Extron electronic 1616 HV, HVA manual Quick Start CrossPoint Plus Matrix Switchers

Quick Start — CrossPoint Plus Matrix Switchers

Installation

Step 1

Mount the switcher in a rack.

Step 2

Turn off power to the input and output devices, and remove the power cords from them.

Step 3

Cable the switcher for RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video input and output (3). See page 2-3 in this manual for details.

Step 4

Cable the switcher for stereo audio input (HVA models). Each input has a 3.5 mm, 5-pole captive screw connector for balanced or unbalanced stereo audio input (4). Connectors are included with each switcher, but you must supply the audio cable. High impedance is generally over 800 ohms.

Step 5

Cable the switcher for stereo audio output (HVA models). Each output has a 3.5 mm, 5-pole captive screw connector that outputs the selected unamplified, line level audio. Connect an audio device, such as an audio amplifier or powered speakers (5).

3

5

Tip	AUDIO
Tip
See caution
Sleeve
See caution
Unbalanced Output
Tip	AUDIO
Tip
Ring
Sleeve (s)
Ring

Balanced Output

6

4

Tip

Sleeve

Tip

Sleeve

Unbalanced Input

(high impedance)

Tip

Ring

Sleeve (s)

Tip

Ring

Balanced Input

(high impedance)

600 ohms

Tip

Ring

Sleeve (s)

Tip

Ring

600 ohms

Balanced Input

(600 ohms)

CAUTION Connect the sleeve to ground. Connecting the sleeve to a negative (-) terminal will damage the audio output circuits.

Step 6

If desired, connect a control system or computer to the Remote RS-232/RS-422 port (6).

Step 7

5	1	1	5
9	6	6	9
Female		Male

Plug the switcher, input devices, and output devices into a grounded AC source, and turn on the input and output devices.

Definitions

The following terms are used throughout this manual:

Tie — An input-to-output connection.

Pin RS-232 Function

1	—	Not used
2	TX	Transmit data
3	RX	Receive data

4— Not used

5Gnd Signal ground

6— Not used

7— Not used

8— Not used

9— Not used

RS-422	Function
TX-	Transmit data (-)
TX+	Transmit data (+)
RX+	Receive data (+)
RX-	Receive data (-)
Gnd	Signal ground
—	Not used
—	Not used
—	Not used
—	Not used

Set of ties — An input tied to two or more outputs. (An output can never be tied to multiple inputs.)

Configuration — One or more ties or sets of ties.

Current configuration — The currently active configuration (also called configuration 0).

Preset — A configuration that has been stored. One preset can be assigned to each input button. When a preset is retrieved from memory, it becomes the current configuration.