Config

System

3Enter the path and file name or select Browse to locate the file.

4Select OK.

IP alias ranges

When adding an IP alias you can include an IP address range as well as individual addresses. For example:

10.10.10.1 - 10.10.10.50

10.10.10.1 - 10.10.20.100

Configuring RAID

FortiAnalyzer units containing multiple hard disks can store data using a RAID array to provide redundant storage, data protection, faster hard disk access, or a larger storage capacity.

RAID settings can be configured from the Dashboard, in the RAID Monitor widget as well as from System > Config > RAID.

Caution: Fortinet recommends using RAID 10 if your FortiAnalyzer unit uses software ! RAID and redundancy is required. Using RAID 5 causes system performance issues.

Note: RAID functionality is only available on the FortiAnalyzer-400, FortiAnalyzer-800/800B, FortiAnalyzer-2000/2000A and FortiAnalyzer-4000/4000A. These units include multiple hard disks for RAID support.

Array capacity is limited to 8 TB. This limit is included only in the following previous releases:

FortiAnalyzer 3.0 MR6 patch release 1

FortiAnalyzer 3.0 MR5 patch release 5

RAID levels

All FortiAnalyzer units support standard RAID levels 0, 1, 5 and 10. Other RAID support varies by model:

FortiAnalyzer-100A/100B: none

FortiAnalyzer-400: Linear, 0, 1, 5, 10 (RAID5 is configured in the CLI)

FortiAnalyzer-800/800B: Linear, 0, 1, 5, 10 (RAID5 is configured in the CLI)

FortiAnalyzer-2000/2000A: 0, 10 5, 50, 5 with hot spare

FortiAnalyzer-4000/4000A: 0, 10 5, 50, 5 with hot spare

If a hard disk fails, and the selected RAID level cannot be accomplished using the number of remaining hard disks, the FortiAnalyzer unit rebuilds the RAID using the default RAID level. Default RAID level varies by model. By default, FortiAnalyzer models with hardware RAID controllers use RAID 5; models with software RAID controllers use RAID 10.

FortiAnalyzer units that contain software RAID are the FortiAnalyzer-400, FortiAnalyzer-800/800B units. Hardware RAID is found on higher-end models, such as FortiAnalyzer-2000/2000A, FortiAnalyzer-4000/4000A.

You can find out information about RAID from the get system status command or diag raid info in the CLI.

 

FortiAnalyzer Version 3.0 MR7 Administration Guide

62

05-30007-0082-20080908

Page 62
Image 62
Fortinet 3.0 MR7 manual IP alias ranges, Configuring RAID, RAID levels