Frymaster 8196345 manual Probe, Failure, FAILURE with, Ignition, igNITION, FAILURE and, HI 2 BAD

Problem	Probable Causes	Corrective Action
CM7 display shows	Problem with the temperature	This indicates a			problem		within
		the	temperature			measuring
PROBE	measuring circuitry including the
		circuitry.		Check		resistance of
FAILURE.	probe.
		probe, if faulty replace probe.
CM7 display shows		Swap the computer wiring harness
PROBE	Damaged computer wiring harness or	with one known to be good. If
FAILURE with	connector.	problem is corrected replace the
alarm sounding.		harness.
		Is displayed if the fryer loses its
CM7 display shows		ability to heat oil. It is also
	Open drain valve, failed computer,	displayed		when		the	oil
IGNITION	failed interface board, open high-	temperature		is	above		450°F
FAILURE.	limit thermostat.	(232°C) and the high-limit
		thermostat has opened, halting the
		heating of the oil.
Computer will not
go into program
mode or some	Failed computer.	Replace computer
buttons do not
actuate.
CM7 display shows
low temp,	A. Failed computer.	A. Replace computer.
heating indicator
cycles on and off	B. Damaged computer wiring	B. Replace computer wiring
normally but fryer	harness.	harness.
does not heat.
CM7 display shows	Drain valve not fully closed.	Press the reset switch on the MIB
igNITION		board.	All	drain		valves	should
FAILURE with		close. Using the ON/OFF switch,
alarm sounding.		turn the computer OFF and then
Heating indicator is		ON again.
on, but fryer is not
heating.
CM7 display shows
IGNITION
FAILURE and		Replace computer.
alarm sounds, but	Failed computer.
fryer operates
normally (false
alarm).
CM7 display shows		This is displayed only during a
	Computer in high-limit test mode.	test of the high-limit circuit and
HI 2 BAD.		indicates that the high-limit has
		failed.

1-34