Frymaster 8196345 manual hot-hi-1, Hi-Limit, Exit, Melt, low temp, Error Rm, Sdcrd, Problem

Problem	Probable Causes	Corrective Action
		E. If any component in the power
		supply	system		(including		the
	E. Power supply component or	transformer		and		interface
	interface board has failed.	board) fail, power will not be
		supplied to the computer and it
		will not function.
Computer locks up.	Computer error.	Remove and restore power to the
		computer.
Heat indicator off
upon initial startup.
Display shows hi or	Failed computer.	Replace computer.
hot with alarm
sounding.
CM7 display is in		See section 1.14.2 on page 1-35 to
wrong temperature	Incorrect display option programmed.
scale (Fahrenheit or		change temperature scale.
Celsius).		This in an indication of a
CM7 display shows	Frypot temperature is more than	malfunction in		the		temperature
	410ºF (210ºC) or, in CE countries,	control	circuitry,		including		a
hot-hi-1.
	395ºF (202ºC).	failure	of	the		high-limit
		thermostat.
CM7 display shows		This is displayed only during a
	Computer in high-limit test mode.	test of the high-limit circuit and
HI-LIMIT.		indicates that the high-limit has
		opened properly.
		This display is normal when the
		fryer is first turned on while in the
		melt cycle mode. To bypass the
		melt cycle press and hold a #2
		product button under the LCD
		display until a chirp is heard. The
CM7 display shows	Frypot temperature is between 180°F	alarm will chirp and the computer
		displays	EXIT			MELT
low temp.	(82°C) and 315°F (157°C).	alternating with YES NO. Press
		the #1 YES button to exit melt. It
		may appear for a short while if a
		large batch of frozen product is
		added to the frypot. If the display
		never goes out, the fryer is not
		heating.
CM7 display shows
ERROR RM	Defective SD Card	Replace card with another card.
SDCRD

1-33