Problem | Probable Causes |
CM7 display shows |
|
software for only | Loose or damaged harness |
CM7. |
|
|
|
1.14.2 CM7 Useful Codes
Corrective Action
Check that all harnesses between CM7’s and ATO are secure. Check for loose pins. If the problem persists, swap out computer from one bank to another and reinitialize.
To enter any of the following codes: Press the UNLOCK ▼ button three times. TECH is displayed. Press the 9 button. CODE is displayed. Enter a code listed below for the appropriate function.
•Enter Setup in Tech Mode – Enter 7378.
•Change from F° to C° - Enter 1658. The computer displays off. Turn the computer on and check temperature to see the temperature scale. If the desired scale is not displayed, repeat.
•Reset Factory Menu - Enter 3322. The computer display flashes and quickly counts from
•Reset BADCRC Message - Disconnect board locator plug (J10). Reinsert plug. Enter 9988. Computer display switches to off. Remove and then restore power to the computer using the
•Reset RECOVERY FAULT CALL SERVICE – Enter 0042.
•Reset CALL TECH Message - Disconnect board locator plug (J10). Reinsert plug. Enter 1000. Computer display switches to off. Remove and then restore power to the computer using the
PASSWORDS
Program Mode: Press the UNLOCK ▼ button once. The computer displays PROGRAM. Press the 9 button. ENTER CODE is displayed. Enter 1650.
Manager Mode: Press the UNLOCK ▼ button twice. The computer displays MANAGER. Press the 9 button. ENTER CODE is displayed. Enter 4321.
Tech Mode: Press the UNLOCK ▼ button three times. The computer displays TECH. Press the
9button. CODE is displayed. Enter 7378.