4.Wrap the motor with plastic wrap to prevent water from entering it. Spray degreaser or detergent on the blower wheel and the blower housing. Allow it to soak for five minutes. Rinse the wheel and hous- ing with hot tap water, then dry with a clean cloth.
| Wrap the motor and |
| wires with plastic wrap |
| or a plastic bag. |
BLOWER HOUSING | BLOWER WHEEL |
5.Remove the plastic wrap from the blower motor assembly. Reassemble the blower motor assembly and blower housing. Reinstall the blower assembly in the cooker and reconnect the wires disconnected in Step 1.
4.Reinstall the blower shield or shield assembly.
5.Light the cooker in accordance with the procedure described in Chapter 3, Section 3.1.
6.After the burners have been lit for at least 90 seconds, observe the flames through the burner viewing ports. The air/gas mixture is properly adjusted when the burner manifold pressure is in accordance with the applicable table on page
On the side of the blower housing opposite the motor is a plate with one or two locking nuts. Loosen the nut(s) enough to allow the plate to be moved, then adjust the position of the plate to open or close the air intake opening until a bright