Frymaster KSCF18G manual Gas Connections, Countries Supply Pressures Appliance Gas mbar Categories

KSCF18G COOL ZONE SERIES GAS FRYERS

CHAPTER 3: INSTALLATION INSTRUCTIONS

3.3 Leveling the Fryer (cont.)

ANSI Z83.11/11a-(Latest Edition) requires a fryer be restrained to prevent tipping when installed in order to avoid the splashing of hot liquid. The means of restraint may be the manner of installation, such as connection to battery of appliances or installing the fryer in an alcove, or by separate means, such as adequate ties (chains, straps, etc.). A bracket has been provided on the fryer back panel for this purpose.

NOTE: The installation must be inspected after it is complete to ensure it meets the intent of these instructions. The on-site supervisor and/or operator(s) should be informed that the appliance is installed with restraints. If restraints are removed to move fryer (e.g., to clean beneath and behind, to relocate) ensure that they are re-installed when fryer is returned to its permanently installed position.

For information on fryer restraints, see Section 2.9.

3.4 Gas Connections

KSCF18G Cool Zone Series gas fryers have obtained CE markings for countries and gas categories shown below:

Countries		Supply Pressures		Appliance	Countries		Supply Pressures		Appliance
		and Gas (mbar)		Categories			and Gas (mbar)		Categories
BE	Belgium	G20	20/25	I2E (R) B	GR	Greece	G20	20	II2H3P
		G31	37	I3P			G31	37 and 50
DE	Germany	G20	20	I2E	IR	Ireland	G20	20	II2H3P
		G31	50	I3P			G31	37
DK	Denmark	G20	20	I2H	IT	Italy	G20	20	I2H
ES	Spain	G20	20	II2H3P	LU	Luxembourg	G20/G25	20/25	II2E3P
		G31	37 and 50				G31	50
FR	France	G20/G25	20/25	II2ESI3P	NL	The	G25	25	II2L3P
		G31	37 and 50			Netherlands	G31	50
GB	Great Britain	G20	20	II2H3P	PT	Portugal	G20	20	II2H3P
		G31	37				G31	37

The gas supply (service) line must be the same size or greater than the fryer inlet line. KSCF18G gas fryers are equipped with a ¾-inch (22-mm) male inlet. The gas supply line must be sized to accommodate all gas-fired equipment connected to that gas supply. Consult local gas companies/suppliers or your local contractor for minimum supply line requirements.

3-4