Frymaster KSCF18G manual Legs Only, Rigid Casters Only, Installing Optional Swivel Casters

KSCF18G COOL ZONE SERIES GAS FRYERS

CHAPTER 3: INSTALLATION INSTRUCTIONS

3.3 Leveling the Fryer (cont.)

•Legs (Only)

1.Adjust leg height with an adjustable or 11/16-inch (27-mm) open-end wrench by turning the hex bullet on the bottom of the leg.

2.The hex bullet is for minor leg height adjustment only. Do not adjust more than 1 inch (25 mm).

3.When leveling the unit, the leg body should be held firmly to keep the leg from bending or rotating while turning the hex bullet foot to the required height.

•Rigid Casters (Only)

1.Install rigid casters on the fryer rear channel only. Legs must be installed on the front channel.

2.There are no level-adjustments for the rigid casters.

B.If the floor is uneven or has a decided slope, place the fryer on a smooth platform.

C.If the fryer is moved, re-level the fryer following the instructions given in Steps 3.3, A-C.

D.Installing Optional Swivel Casters

1.Install non-locking casters only at the rear of the unit.

2.Locking casters must be installed at the front of the unit. Locking casters allow the fryer to be "locked" in position for safe operations.

3.Follow the same instructions for leg installations as given above in Steps 3.2, B1-B5.

Front View Rear Side View

Optional Caster-	Optional Caster-
Rear Only	Front Only

Front Channel or Rear Channel

Front or Rear Leg with

Mounting Plate

Adjust as needed

1/4-20 x 3/4 Hex Bolt

Front Channel or Rear Channel

Leg Support Assembly Washer

1/4-20 Hex Head Locknut

1/4-20 x 3/4 Hex Bolt

Rear Caster—5" Rigid	Front Caster—5" Swivel
	w/Brake

Leg and Caster (Optional) Mounting Installation

3-3