Frymaster BIPH55, MPH55 Continued from, Previous page, Filter Pump starts, but no transfer takes

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
	C. Blockage in filter pump.	C. Pump blockages are usually
	Test: Close the drain valve. Place the	caused by sediment build-up in
		the pump due to improperly sized
	filter handle in the OFF position,	or installed filter pad and failure
	allow the pump to cool for at least 45	to use the crumb screen. Use a
Continued from	minutes, and then press the reset	thin flexible wire to remove the
	button on the pump motor. Pull the	blockage. If the blockage cannot
Previous page
	filter pan from the unit. Activate the	be removed, call FASC.
	pump. If the pump motor hums and	Ensure that filter pad is of the proper
	then stops, the pump is blocked. Also
	if air or bubbling oil comes out of the	size and is installed properly, and that
	rear flush port, there is a blockage in	the crumb screen is used.
	the filter pan suction tube.
		A. To properly filter, the oil should
		be at or near 350°F (177°C). At
		temperatures lower than this, the
	A. Cooking oil is too cold for	oil becomes too thick to pass
	filtering.	through the filter medium easily,
		resulting in much slower oil
		return and eventual overheating of
Filter Pump starts,		the filter pump motor.
	B. Improperly installed or prepared
but no transfer takes	filter pan components.	B. Remove the oil from the filter pan
place or the oil		and replace the filter pad,
return is very slow.	Test: Close the drain valve.	ensuring that the filter screen is in
	Move the filter handle to the OFF	place under the pad.
	position, pull the filter pan from	If this does not correct the
	the unit. Move the filter handle to
	the ON position.	problem, the filter suction tube is
		probably blocked. Remove the
	If a strong stream of air is being	blockage using a thin, flexible
	pumped out of the oil return port,	wire. If unable to remove the
	the problem is with the filter pan	blockage, call FASC.
	components.

6-6