Frymaster Protector Series Auto Top-OffProblems, Basket Lift Problems, Probable Causes

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
		A. Paper/screen needs changed or
		cleaned.
		B. If using filter paper
Filter pump runs,		configuration, verify that filter
	A. Paper/screen clogged.	screen is in bottom of pan with
but oil return is very	B. Improperly installed filter pan	paper on top of screen.
slow and bubbling	components.
oil occurs.	C. Attempting to filter with oil that	Verify that O-rings are present
	is not hot enough.	and in good condition on filter
		pan connection fitting.
		C. In order to properly filter, the oil
		should be at or near 350ºF
		(177ºC).
Filter pump runs	Blockage in filter pan suction tube.	The blockage may be caused by
	Test: Close the drain valve and pull	sediment buildup. Use a thin,
but oil does not
	the filter pan out from the fryer.	flexible wire to remove the
return to frypot and
	Activate the pump. If bubbling oil	blockage. If the blockage cannot be
there is no bubbling
	occurs, there is a blockage in the	removed, call FASC.
oil.
	filter pan suction tube.
7.2.4 Auto Top-Off Problems

Problem	Probable Causes
	A. Fryer temperature too low.
Frypots won’t top	B. Temperature of oil too cold.
	C. Supply line out of JIB.
off.	D. CM7 not readdressed after ATO
	switch was switched on.

7.2.5 Basket Lift Problems

Corrective Action

A. Fryer temperature must be at least 300°F (149°C).

B. Ensure that oil is above 70°F (21°C).

C.Ensure supply line is in JIB.

D.Switch all CM7 computers off and then on again to readdress system.

If problem persists call your FASC.

PROBLEM	PROBABLE CAUSES	CORRECTIVE ACTION
Basket lift		Apply a light coating of
	Basket lift rods need lubrication.	Lubriplate™ or similar lightweight
movement is jerky		white grease to the rod and
and/or noisy.
		bushings.

7-5