Frymaster Replace Heating Element cont, Ultimate Electric Series Fryers, Service Procedures

ULTIMATE ELECTRIC SERIES FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.6 Replace Heating Element (cont.)

5.Remove the element clamps and hardware before removing mounting-screws and nuts on the defective element. Remove all wire- ties securing element wiring, and then remove element from frypot.

6.Install the replacement element in the frypot and secure with the mounting hardware removed in Step 5.

7.Reinstall the temperature probe and probe- bracket components onto the replacement element.

8.Route the element leads (terminals) to the rear of the fryer. Ensure the element-harness insulation is in place prior to installing connectors.

Element mounting screws on tilt-plate front. (Inset: element mounting plate on tilt-plate back.)

Ensure element wire insulation is installed and that the wires are properly routed to prevent wire chafing.

9. Secure element wiring with wire-ties.

Use wire-ties (arrows) to secure element wiring.

1-7