Frymaster manual Replace High-Limit, Ultimate Electric Series Fryers, Service Procedures

ULTIMATE ELECTRIC SERIES FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.7 Replace High-Limit

1.Perform Procedure 1.5, Replace Temperature Probe, Steps 1-4.

2.Disconnect the wire harness containing the high-limit wires.

3.Use a pin-pusher (P/N 806-4855 or P/N 807- 0928) to remove the two high-limit wires from the wire harness connector (arrows). Note pin location in connector before removing wires.

4.Remove the high-limit from the frypot using an open-end wrench or other suitable tool.

5.Apply Loc-Tite PST 567 sealant to the replacement high-limit threads.

6.Screw the replacement high-limit into the frypot and tighten to 170-180 inch-pounds torque. DO NOT OVERTIGHTEN.

7.Insert the replacement high-limit wires into the connector, ensuring each wire is in the correct hole..

8.Reconnect the high-limit wire-harness connector.

9.Install and secure the back cover(s).

10.Return fryer to operation.

Using a pin-pusher, remove two high-limit wires (arrows) from connector.

Pin Pusher— P/N 807-0928

Place wrench here when removing and installing high-limit.

1-9