ULTIMATE ELECTRIC SERIES FRYERS
CHAPTER 1: SERVICE PROCEDURES
1.5 Replace Temperature Probe (cont.)
10.Thread the new probe wire through the hole in tilt plate. Place the new temperature probe assembly onto the element and secure with the bracket and screws removed earlier. Clip the probe onto the rear of the element (arrow) in two places. The temperature probe assembly should be oriented in the same manner as the probe being replaced.
11.Thread the probe wires into the harness insulation. Note the pin positions and insert pins in the connector. Reconnect the harness and secure with a
12.Lower the element into the frypot with the lift handle.
13.Place the tilt housing cover over the tilt housing assembly and secure with screws. Slightly raising the elements will facilitate
14.Install back cover(s) and secure with screws
Secure probe bulb to the element back in two places with metal wire wrap (arrow).
Install tilt housing and cabinet backs after probe installation is complete.