Frymaster manual Replace Heating Element, Ultimate Electric Series Fryers, Service Procedures

ULTIMATE ELECTRIC SERIES FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.6 Replace Heating Element

1. Perform Procedure 1.5, Replace Temperature Probe, Steps 1-7.

2.Unplug the element connectors for the element being removed (right element- 6-pin harness connector; left element- 9-pin harness connector). Remove the element wires from the connector. Press down on either side of the connector while pulling up on the top portion. The connector will open from the top. Note wiring configuration in connector before removing element wire pins. Pull all wires from the connector.

3.Remove the screws securing the temperature probe bracket from the element. Remove the probe clamp (metal wire-wrap). Set the temperature probe and probe-securing components aside.

NOTE: Temperature probe removal is not required if the left element is being replaced.

	Harness			Harness
Connector			Connector
	Closed				Open
		Top Portion

Push in on tabs to release

top portion

Remove metal wire wrap (arrow), and screws securing probe bracket to element (inset, arrow).

4.Disconnect the element springs from the tilt brackets.

Disconnect element springs here.

1-6