Cautions

On Windows 98 systems, if you want to disconnect the device from the master connector of the secondary IDE and connect it to the slave connector, you must change the system settings beforehand.

If you want to install an internal option to your PC, set up Windows, turn off the PC, and then install the option.

An internal hard disk drive that supports DMA (Multiword DMA1/2, Ultra DMA/33, or Ultra DMA/66) can be used with the DMA setting.

When installing a hard disk drive or magneto-optical disk drive that does not support DMA, be sure to set DMA to OFF. If it is used with DMA set to ON, the drive may not work properly and may destroy data.

Refer to the manual for the hard disk drive or magneto-optical disk drive to check whether it supports DMA.

The secondary IDE does not support Ultra DMA/66 and Ultra DMA/100. Use the secondary IDE in the Ultra DMA/33, Multiword DMA1/2, or PIO mode.

This PC does not support additional floppy disk drive.

CAUTION

• Before installing or removing an internal option, turn off the PC and all devices connected to it, and unplug them. Otherwise, an electric shock may occur.

• Use Fujitsu-supplied internal options.

Otherwise, an electric shock, a fire or fault may occur.

WARNING

• When installing or removing an internal option, do not remove screws other than those specified.

Otherwise, personal injury or faults may occur.

• When accessing the PC board, touch the specified areas only. Otherwise, you may be injured or a fault may occur.

45

Page 56
Image 56
Fujitsu 500 user manual