Fujitsu 600C manual Table of Contents, General, Specifications, Operation, Interface

	Table of Contents
1. GENERAL		1-1
1.1	GENERAL	1-1
1.2	DEVICE CONFIGURATION	1-3
1.2.1 Outer View		1-3
1.2.2 Components		1-4
2. SPECIFICATIONS		2-1
2.1	FUNCTIONAL SPECIFICATIONS	2-1
2.2 ENVIRONMENTAL SPECIFICATIONS		2-2
3. OPERATION		3-1
3.1	REMOVING THE SHIPPING BRACKET	3-1
3.2	POWER ON/OFF	3-3
3.3	INDICATION PANEL	3-3
3.4	SETTING THE SCSI ID AND CONNECTING THE INTERFACE CABLE	3-4
3.4.1 SCSI Cable Connection		3-5
3.5	PAPER SPECIFICATIONS	3-7
3.5.1 Paper Size		3-7
3.5.2 Paper conditions		3-7
	3.5.2.1 ADF	3-7
	3.5.2.2 FIatbed	3-8
	3.5.2.3 Items to avoid	3-8
3.5.3 Readable area		3-9
3.6	DOCUMENT SETTING METHOD	3-10
3.6.1 Flatbed		3-10
	3.6.1.1 When the document size is of letter/A4 size or smaller	3-10
	3.6.1.2 When the document is a thick book	3-11
3.6.2 ADF		3-11
	3.6.2.1 Setting the ADF paper chute	3-11
	3.6.2.2 Placing the documents on the ADF paper chute	3-12
3.7	CLEANING	3-14
3.7.1 Cleaning the document cover and the document glass		3-14
3.7.2 Cleaning inside the ADF		3-15
4. INTERFACE		4-1
4.1	PHYSICAL SPECIFICATIONS	4-3
4.1.1 Connection		4-3
4.1.2 Physical Specification		4-4
4.1.3 Termination		4-4
4.1.4 Pin assignments		4-5
4.2	SCSI BUS	4-6
4.2.1 System configuration		4-6
	4.2.1.1 System configuration	4-6
	4.2.1.2 Addresses of SCSI devices	4-6
	4.2.1.3 Peripheral equipment	4-6
4.2.2 Bus signals		4-7
4.2.3 Bus signal drive conditions		4-8
4.3	BUS PHASES	4-9
4.3.1 BUS FREE phase		4-11
4.3.2 ARBITRATION phase		4-12
4.3.3 SELECTION phase		4-14
4.3.4 INFORMATION TRANSFER phases		4-15
	4.3.4.1 Asynchronous information transfer	4-16
4.4	COMMANDS	4-18
4.4.1 RESERVE UNIT command		4-19
	4.4.1.1 RESERVE UNIT command: COMMAND phase (initiator Õ target)	4-20
4.4.2 RELEASE UNIT command		4-21
	4.4.2.1 RELEASE UNIT command: COMMAND phase (initiator → target)	4-21

iii