Fujitsu 600C manual RESERVE UNIT command COMMAND phase initiator Õ target, a TP third party Byte

4.4.1.1RESERVE UNIT command: COMMAND phase (initiator Õ target)

Where a logical unit can be accessed by two or more initiators, there could be interferences with command sequences, data, etc. This situation can be avoided by issuing the RESERVE UNIT command before initiating series of operations.

Once a logical unit has properly accepted the RESERVE UNIT command, it will be occupied by the initiator that issued the RESERVE UNIT command. If the 3rd party reservation option is supported, the logical unit might be occupied by another SCSI unit - one having an initiator function - which is specified TPID. In this condition called "reserved;' the logical unit cannot be accessed from any other initiators. The reserved condition remains effective until one of the following events take place:

1.The reservation is replaced by a new RESERVE COMMAND from the same initiator that has reserved the logical unit. (issuing another RESERVE UNIT command with the reservation still effective does not result in an error. The previously established reservation is released as a result of 2,3, or 4 described below.)

2.The RELEASE UNIT command is issued from the same initiator that has reserved the logical unit.

3.The BUS DEVICE RESET message is sent from any initiator.

4.A hardware reset condition is detected.

The condition in effect after 3 or 4 is indicated by a sense key X'6' (UNIT ATTENTION), which is returned in response to a subsequent command.

When a logical unit is already reserved by another initiator, if a command other than RELEASE UNIT, INQUIRY, or REQUEST SENSE is issued, the target returns the following status:

Status: B'01100' (RESERVATION CONFLICT)

The initiator having reserved a logical unit can change the reservation by issuing the RESERVE UNIT command to the same logical unit.

The command descriptor block (CDB) of this command is shown in the following illustration.

Byte 0

1

2

3

4

5

7	6	5	4	3	2	1	0
			Operation code X'16'
	Logical unit number		TP		TPID		(Reserved)

(Reserved)

Control byte

(a)TP (third party): Byte 1

If the 3rd party reservation option is not supported, setting this bit to 1 causes the target to return the

following error:

∙Status key: B'00001 '(CIIECK CONDITION)

∙Sense key: X'5' (ILLEGAL REQUEST)

This scanner does not support the 3rd party reservation option.

(b)TPID (third party device ID): Byte 1

This scanner ignores TPID.

4-20