Fujitsu 600C manual 3.6.2 ADF, When the document is a thick book, Setting the ADF paper chute

3.6.1.2When the document is a thick book

1.Open the document cover and place it on the glass surface.

2.If the document is thick, do not close the document cover.

That part of the document in close contact with the glass will be read correctly but any part that is not in contact with the glass may be unclear or distorted so care must be taken.

3.6.2ADF

3.6.2.1Setting the ADF paper chute

Figure 3-7 Setting the ADF paper chute

To use ADF to read the documents, set the ADF paper chute as follows:

1.Raise the unattached end of the input paper chute to about 45 degrees, as shown in Figure 3.7.

2.Pull down the metal bracket from under the paper chute.

3.Click the metal bracket into the grips on the document cover.

4.Pull the chute extension up.

3-11