∙The current parameter(s) is (are) not allowed. Please use (an)other parameter(s) and try scanning again.
Cause: | An incorrect value has been specified for the image scanner. The |
| problem may be due to an illegal combination with the specification |
| value from the application. |
User response: | Change the specification values. Then, try scanning again. |
∙The scanner is in an irregular status; fuse is broken, etc. Please check the scanner status.
Cause: | A scanner fault such as a blown fuse or foreign matter in the scanning |
| section has occurred. |
User response: | Check the scanner status. If a fuse has blown, replace the fuse. If |
| there is foreign matter in the scanning section, remove the foreign |
| matter. If the error persists, contact the retail store where the image |
| scanner was purchased or the nearest maintenance and service center. |
∙Memory is insufficient.
Cause: | Insufficient memory for scanning. The memory available may be |
| insufficient because an application consuming much GDI memory is |
| operating, too many other programs operate at the same time, or there |
| are too many registered device drivers. The user may mistakenly |
| think that adding more memory will solve this problem. However, in |
| most cases, memory shortage is due to insufficient conventional |
| memory (called the main memory within 640 kilobytes). Checking |
| CONFIG.SYS and AUTOEXEC.BAT may be a better solution. |
User response: | Cancel the registration of device drivers that are irrelevant and make |
| sure that only the absolutely necessary programs are operating. Use |
| the memory optimization tool to allocate as much conventional |
| memory as possible. |
∙An error occurred in the temporary file.
Cause: | Accessing the internal temporary file of the scanned image is causing |
| the error. The disk space may be insufficient, the temporary file may |
| be damaged, or other programs may be affecting disk access. |
User response: | Increase the free space of the disk. Check the hard disk (chkdsk and |
| scandsk). Make sure that no other program is accessing the disk. If |
| the error message persists, contact the retail store where the product |
| was purchased or the nearest service center. |
∙Download file not found.
Cause: | A file specified as a dither pattern or gamma pattern cannot be found. |
User response: | Check that the download file is in the specified directory. Otherwise, |
| use the file selection dialog to specify an available file. |
66
