Fujitsu DL6400Pro, DL6600Pro user manual Fcntadj, Rcntadj, Cut-Adj

Changing Print Adjustment Options

Table 8–5 ADJUST options (Continued)

ADJUST item		Options			Description
<FCNTADJ>					Compensates for cumulative line-spacing errors resulting
					from front feeding continuous forms 22 inches.
		-22/360, ..., 0,			Decreases or increases in 1/360-inch increments.
		..., +22/360
<RCNTADJ>					Compensates for cumulative line-spacing errors resulting
					from rear feeding continuous forms 22 inches.
		-22/360, ..., 0,			Decreases or increases in 1/360-inch increments.
		..., +22/360
<CUT-ADJ>					Compensates for cumulative line-spacing errors
					resulting from feeding cut sheets 10 inches.
		-22/360, ..., 0,			Decreases or increases in 1/360-inch increments.
		..., +22/360
<==END==>					Indicates the end of the ADJUST item list. Press
					FONT to print the first item, <CNT-ORG>. Press
					MENU to print the last item, <CUT-ADJ>. Press
					ONLINE to reprint the <<FUNCTION>> menu.
		Note:
		Underlined options are the factory default settings.
		Before adjusting a print position, measure the amount of adjustment
		required for paper preprinted with ruled lines, and thus requiring
		precise print registration. To adjust a print position, check that
		continuous forms are loaded. The following procedure adjusts the top-
		of-form setting for cut sheets.
	1.		Enter setup mode.
			Place the printer offline and then press FONT and MENU
			simultaneously. Wait for the printer to stop printing and check that
			the <<FUNCTION>> menu is printed:
<<FUNCTION>>
SAVE&END	MENU1 MENU2		HARDWRE	ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT	GAP-ADJ			(GAP-ADJ is printed only with APTC installed.)

8-30 User’s Manual