Fujitsu DL6400Pro, DL6600Pro user manual Loading, Forms Rear Cutting

Loading Continuous Forms (Rear)

Loading	Refer to the Rear-Feed Tractor User’s Manual for information on the
Continuous	rear-feed tractor option.
Forms (Rear)
Cutting	Forms are cut at perforations 23.3 mm (11/12 inch) above the print
Continuous	head center when the print head center is on the sixth line. A single line
Forms	feed is 4.2 mm (1/6 inch)..
	Perforations
	23.3 mm
	(11/12 in)
	Print head center

1.Press the TEAR OFF button on the control panel. The continuous forms are then automatically loaded to where they are to be cut. For the operation of the printer with the LCD control panel, see Appendix E.

2.Open the noise-proof cover.

3.Check that the perforations are at the paper cutter.

4.Cut the continuous forms as shown in the figure below.

4-6 User’s Manual