Fujitsu DL6600Pro, DL6400Pro user manual Lf/Ff, Load

Using the Control Panel

3. Buttons (when printer is online)

ONLINE:	Places the system offline after it prints the current
	line.
LF/FF:	Line feed/forms feed button. Feeds forms forward.
	Pressing this button continuously for 3 seconds or
	more feeds lines forward to the feed point for the
	next page (forms feed).
	When the cut-sheet feeder is used, pressing this
	button continuously for 3 seconds or more unloads
	forms. If forms are not at the platen, forms are not
	loaded, but a line feed occurs.

TEAR OFF: Places the system in tear off mode and feeds lines to

	the forms cutting point. Tear off mode is valid for
	continuous forms only.
	When this button is pressed, the printer performs
	centering, and the ONLINE lamp blinks.
	If any button is pressed after forms are cut, the buzzer
	sounds, the ONLINE lamp stops blinking, and
	forms are fed back to their previous location.
LOAD:	Loads or unloads forms as follows, depending on the
	situation:
	• Continuous forms at the platen
	Forms are fed backward on the tractor until a paper
	outage is detected. If a paper outage has not been
	detected when forms have been fed 22 inches,
	forms feeding stops.
	• Cut sheets at the platen
	Cut sheets are unloaded if printing has not started,
	and the TOP MARGIN value is made the current
	vertical location.
	• Cut-sheet feeder set and cut sheets at the platen
	Cut sheets are unloaded if printing has not started,
	and the next cut sheet is loaded from the cut-sheet
	feeder. The TOP MARGIN value is made the
	current vertical location.
	• Continuous forms or cut sheets being used, cut-
	sheet feeder set, and no forms at the platen

OPERATING THE PRINTER

User’s Manual 5-3