5.4Mounting Drives
5.4.1Check before mounting
Reconfirm if the setting terminals are set correctly before mounting the drive in the system cabinet. For setting terminals location, see Section 5.3.
(1)
Reconfirm if the setting terminals are set correctly according to Table 5.7.
Setting terminal CN6
Setting terminal CN7
Table 5.7 Setting check list (MAx3xxxSP)
No. | Setting contents | Setting | Check |
| Remarks | |
(Check item) | position |
| ||||
|
|
|
| |||
|
|
|
|
|
|
|
1 | Terminal power supply | CN6 | 1 - 2 | Short | Open |
|
|
|
|
|
|
|
|
2 | Motor start mode | CN6 | 3 - 4 | Short | Open |
|
|
|
|
|
|
|
|
3 | Connection of terminating | CN6 | 5 - 6 | Short | Open |
|
| resistor on SCSI interface |
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| |
No. | Setting contents | Setting | Check |
| Remarks | |
(Check item) | position |
| ||||
|
|
|
| |||
|
|
|
|
|
| |
1 | SCSI ID | CN7 | 7 - 8 | (SCSI ID = __) |
| |
|
|
| 5 - 6 |
|
|
|
|
|
| 3 - 4 |
|
|
|
|
|
| 1 - 2 |
|
|
|
|
|
|
|
|
|
|
2 | Write protect | CN7 | 13 - 14 | Short | Open |
|
|
|
|
|
|
|
|
5.4.2Mounting procedures
Since mounting the drive depends on the system cabinet structure, determine the work procedures considering the requirements specific to each system. The general mounting method and items to be checked are shown below.
See Subsection 4.2 for the details of requirements for installing the IDD.
1)With a system to which an external operator panel is mounted, if it is difficult to access the connector after the drive is mounted on the system cabinet, connect the external operator panel cable before mounting the drive.
2)Fix the drive in the system cabinet with four mounting screws as follows:
∙The drive has 10 mounting holes (both sides: 3 ×2, bottom: 4). Fix the drive by using four mounting holes of both sides or the bottom.
| 5 - 11 |
