Fujitsu USDLH532 manual Problem Possible Cause Possible Solutions Video Problems

Problem	Possible Cause	Possible Solutions
Video Problems
The built-in display is blank	The notebook is set for an exter-	Pressing [F10] while holding down the [Fn] key allows you to change your selec-
when you turn on your LIFE-	nal monitor only.	tion of where to send your display video. Each time you press the keys you will step
BOOK notebook.		to the next choice. The choices, in order are: built-in display only, external monitor
		only, both built-in display and external monitor.
	The display angle and bright-	Move the display and the brightness control until you have adequate visibility.
	ness settings are not adequate‘	Pressing either the [F6] or [F7] keys while holding down the [Fn] key also allows
	for your environment.	you to change the brightness level of the display.
	Power management timeouts	Press a keyboard button or move the mouse to restore operation. If that fails, push
	may be set for short intervals	the Power/Suspend/Resume button. (The display may be shut off by Standby mode,
	and you didn’t see the display	Auto Suspend or Video Timeout)
	come on and go off.
The notebook turned on with	Power On Self Test detected a	Contact your support representative.
a series of beeps and the	failure that does not allow the
built-in display is blank.	display to operate.
The display goes blank by	The notebook has gone into	Press any button on the keyboard, or move the mouse to restore operation. If that
itself after you have been	Video timeout, Standby, or	fails, push the Power/Suspend/Resume button. Check your power management set-
using it.	Save-to-Disk mode because you	tings, or close your applications and go to the Power Savings menu of the setup
	have not used it for a period of	utility to adjust the timeout values to better suit your operation needs. See “BIOS
	time.	Setup Utility” on page 36.
	Power management timeouts	Press any button on the keyboard, or move the mouse to restore operation. If that
	may be set for short intervals	fails, push the Power/Suspend/Resume button. (The display may be shut off by
	and you didn’t notice the display	Standby Mode, Auto Suspend or Video Timeout)
	come on and go off.
Your display won’t turn on	The system may be password-	Check the status indicator panel to verify that the Security icon is blinking. If it is
when the system is turned on	protected.	blinking, enter your password.
or when it has resumed.
The display does not close.	A small object such as a paper	Remove all foreign objects from the keyboard.
	clip is stuck between the display
	and keyboard.

69 - Troubleshooting