Furuno 1724C, 1734C manual Inserting a Chart Card

1. OPERATIONAL OVERVIEW

1.2Inserting a Chart Card

Your unit reads SD cards, in the following formats: Navionics GOLD Chart cards or C-MAP NT+/NT MAX chart cards, depending on the type of display unit you have. Insert the appropriate chart card for your area as follows:

1. Open the chart drive.

Chart slot

Display unit

2.Insert chart card label side up.

3.Close the lid.

To remove chart card, follow the steps shown below.

1.Press the MENU key to show the menu.

2.Press the SHOW/HIDE soft key.

3.Open the chart drive lid, and then push the card once and then pull it out.

Note 1: Do not remove a card while the chart is being drawn. This may cause the equipment to freeze.

Note 2: Do not insert or remove a card while the power is on. This may cause the equipment to freeze.

Note 3: For multiple display units, do not use the same chart card type in more than one display unit.

Note 4: Remove the card with care; rough handling can damage the card and destroy its contents.

1-4