Furuno 1734C, 1724C manual Outputting TLL Data, Target soft keys

2. RADAR OPERATION

2.21 Outputting TLL Data

Target position data can be output to units of the network and shown on their plotter screen with the TLL mark (X). This function requires position and heading data.

1.Operate the Cursor pad to place the cursor on the target whose position you wish to output.

2.If not displayed, press the HIDE/SHOW key to display the radar soft keys.

3.Press the TARGET soft key.

.250/	.125nm	319.9	° M	TARGET
SP
H-UP

TRAIL

TLL

OUTPUT

ACQ

TARGET

INFO

RETURN

+359.9° R 0.240nm

Shown with selection of 18x4C/19x4C series network radar equipped with ARP function as source.

Not shown otherwise.

TARGET soft keys

4.Press the TLL OUTPUT soft key to output target position data. The TLL mark appears on the plotter screen at the target’s position the moment the TLL OUTPUT soft key was pressed. Further, that position is recorded as a waypoint on all NavNet units, under the youngest empty waypoint number on each NavNet unit.

5.Press the RETURN soft key to finish.

Note: The screen of the TLL recipient may be temporarily interrupted when receiving TLL from another NavNet display unit. Press any key to restore normal operation.

2-23