Automatic acquisition area

2. RADAR OPERATION

2.Press the TARGET soft key.

3.Place the cursor on the target to acquire.

4.Press the ACQ soft key.

5.Press the RETURN soft key to finish.

The plot symbol changes over time as below. A vector appears about one minute after acquisition, indicating the target’s motion trend.

 

 

 

 

Vector

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

01*

01*

01*

 

Target Number

 

At acquisition

1 min. after

 

3 min. after

 

 

 

acquisition

 

acquisition

 

 

*= Target number shown when TARGET ID NUMBER is turned on in the ARP SETUP menu.

ARP plot symbols

Note: In case of the acquisition by an external ARP, the acquisition circle mark appears one minute after acquisition.

Automatic acquisition

The ARP can acquire up to ten targets automatically by setting an automatic acquisition area. When automatic acquisition is selected after acquiring targets manually, only the remaining capacity for targets may be automatically acquired. For example, if seven targets have been manually acquired, three targets may be automatically acquired.

Automatic acquisition area

45° port

45° starboard

2.0 - 2.5 nm

1. Press the MENU key to show the main menu.

2.Press the ARP SETUP soft key to show the ARP SETUP menu.

3.Operate the Cursor pad to select AUTO ACQUISITION AREA.

4.Press the EDIT soft key to show the automatic acquisition area window.

AUTO ACQ. AREA §

°ON

OFF

Automatic acquisition area window

5.Select ON, then press the ENTER soft key.

6.Press the MENU key to close the menu. An acquisition area of 2.0 to 2.5 miles in range and ±45º on either side of the heading line in bearing appears.

Note: Targets being tracked in automatic acquisition are continuously tracked when switching to manual acquisition.

2-30

Page 61
Image 61
Furuno 1724C, 1734C manual ARP plot symbols, Automatic acquisition area window