Furuno 1933C-BB, GD-1900C-BB, 1953C-BB, 1943C-BB, 1823C-BB Mounting the optional mounting bracket

12. Pass the cable from the rotation detector through two cable clamps.

Rotate detector

Cable clamps

Cable tie (Another should be inside.)

Antenna unit, clamping the rotation detector cable

13.Follow the instructions on the label inside the mounting base to secure the snap assy.

14.Confirm that the rubber gasket is properly positioned and that the triangle mark on the radome cover is aligned with the triangle mark on the mounting base, then tighten the fixing screws for the cover. Refer to the figure of sectional view on the previous page for positioning of rubber gasket.

Mounting the optional mounting bracket

A mounting bracket for fastening the antenna unit to a mast on a sailboat is optionally available.

Mounting bracket 2
Type:	OP03-93
Code No.:	008-445-080
		Type	Code No.	Qty
Hex. bolt		M4x12	000-804-725	4
Hex. bolt		M8x20	000-805-707	8
Mounting plate		03-018-9001-0	100-206-740	1
Support plate (1)		03-018-9005-0	100-206-780	1
Support plate (2)		03-018-9006-0	100-206-790	1
Bracket (1)		03-028-9101-0	100-206-810	1
Bracket (2)		03-028-9102-0	100-206-820	1
Fixing plate		03-028-9103-0	100-206-830	2

Assemble the mounting bracket and fasten it to a mast. Fasten the antenna unit to the bracket. For details, see the figure on the next page.

1-11